Extang Tuff Tonno: Ford F150 04-08 Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
Extang Corporation, 1901 E. Ellsworth Rd., Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409, Visit us at: www.extang.com
7
6
Insert side rail
clamp all the
way into rail.
Attach U-shaped clamp to
siderail clamp with allen bolt.
Insert side rail clamp all the way into rail.
Insert bow onto top or bottom peg.
(Top peg for performance, Bottom for good looks.)
Ends are spring loaded
for easy installation.
Push and hold on
spring end and let the
other end slide on with
the spring action.
SPECIAL
FEATURE:
Two pegs
offer two
height
adjustments.
Note:
Bow End does not
fit between pegs.
For each clamp mark on your
bedliner a 1-1/2” x 3” hole as
shown above. Remove clamp.
Cut holes in bedliner. Reinsert
side rail clamp. Return to step 5.
Side rail clamped
to bed with bow
attached.
877
B
9
EASY USE OF TRUCK BED
Tarp may be rolled up and secured with
Velcro® for bulk hauling
LONGBED (4 clamps)
SHORTBED (3 clamps)
Clamp Spacing (Same for each side) See the stickers located on each side
rail for clamp position, or refer to the dimensions given below.
Note: Use clamp
intended for each position.—Remove stickers after installation.
12
inches
12
inches
Evenly space middle clamps
Lrg.
Clamp
X-Lrg.
Clamp
X-Lrg.
Clamp
X-Lrg.
Clamp
12
inches
Center middle clamp
12
inches
Lrg.
Clamp
X-Lrg.
Clamp
X-Lrg.
Clamp
5
Place the rail assembly over the side of the truck
box. Center rails evenly between cab and tailgate.
(NOTE: Some applications have hard rubber risers (square rubber
pad.) A riser must go toward tailgate. Some applications will have
a riser at both ends, (most have no riser).
A
If a gap is present between the
cab rail and truck bed, apply extra
cab rail foam seal to the bottom
of the existing cab rail seal.
A. Release lever on both corners of
tailgate rail and tilt rail up.
D. Finish attaching tarp along each side by
pushing down and sliding you hand towards
each corner. You can feel the “grip” action.
C. Close-up of downward rotation of rear
rail. You will feel the “snap” effect and see
it tighten snugly.
PUSH
DOWN
PRESS & SLIDE
YOUR HAND
B. Attach tarp at front by pressing
down on edge of tarp with the palms
of your hands (about only 12 inches
on each side). Then hook tarp to the
tails rail’s groove and click down to
tighten tarp. See close-up.
DIAGRAM
Upper
Peg
Lower
Peg
Do Not
Place
Between
the Pegs
For an OVER-THE-RAIL
Bedliner
Note: For over-the-rail bed
liners first refer to Diagrams
A and B above.
DIAGRAM
Place Clamp
Here
STICKER
Vista de pagina 1
1 2

Comentarios a estos manuales

Sin comentarios